|
advice for custom spacer : before make custom spacers you have to do few measures
each hub spigot and wheel center bore
hub spigot can be measured with a caliper BUT center bore have to use bore gages
my front spigot are 66,48mm
my rear 66,46mm
-> So i took 66,53 spacer bore
i have two set of wheel, winter wheel are 66,74 and summer wheel 66,7
-> So i took 66,65mm spacer spigot
when i installed the spacer it was perfect, no play and fit perfectly (the proof that the measures was good)
so, to be sure, do measure before spend money making custom spacer
and when you received your spacer, measure it to check if it is compliant to your requirements
AND DONT FORGET TO USE LONGER BOLT RELATED TO THE SPACER THICKNESS
Last edited by Frenchstar-57; 10-20-2022 at 02:44 PM..
|