I've never torqued down screws holding a heatsink down to any spec. I would just evenly "torque" down the screws to the point where you feel decent resistance and then stop.
I've don this on a myriad of computer hardware to include servers costing in the 5 figures and have never had a problem. I've also observed other techs that don't torque the screws to a spec. It's all by feel. But with what you've shown with the 5.3 in lb spec, it's not a lot of torque/force.
__________________
Quote:
Originally Posted by Lups
We might not be in an agreement on Trump, but I'll be the first penis chaser here to say I'll rather take it up in the ass than to argue with you on this.
|
|