Guys, as promised, here are the DIY on how to remove it.
All you need, long flat screw driver, needle pick, and some muscle.
So here are the steps.
Note: Tape up with painter tape around it, to avoid scratches.
Step 1:
- Turn the steering wheel inward so you have access to the back of the bumper. If you are working on the driver side, then turn the steering wheel to the right and vice versa.
- Locate the 2 clip (Circled in Red) from the back side of the bumper airduct, and use long flat screw driver to undo the clip. (You will need to grab on it from the front so it won't clip back by itself).
Step 2:
- Locate the 2 clips (Circled in Red) from the bottom of the trim, right above the fog light.
For these clips, it is very hard to press in, so I uses pick to pull the trim edges downward.
Step 3:
- Gently pull the trim inward. Just be careful that there are 3 additional clips (Circled in Red) on the top. It may need some effort to pull them off, but shouldn't be that hard.
That's how to remove the trim. Installing it back, just as easy as aligning all the clips and push inward.
Good luck and feel free to PM for any question.