|
For pre LCI models. Just did this.
3531 LaMaster2 > c_AFS_ENA > enable is in LaMaster1 at the end of the list
Both of these are in LaMaster2.
3532 LaMaster3 > c_HBA_ENA > enable [was already enabled]
3532 LaMaster3 > c_HBA_GFHB_ENA > enable
Follow all other steps in OP first post.
VLD is subtle. Its based on speed. The high beam is more noticeable because its a quick off on the sides or middle of your car but blue high beam light is still on.
Also, I don't have fog lights so the fog light speed might not work? Says only if you turn on fog lights.
Last edited by Scotty B; 12-04-2021 at 02:08 AM..
|