|
Thanks you for your help!
But there has unfortunately been a slight change of plans. They could not make a 5x120 setup as they failed QC stress testing.
I am desperate to run these rims! So I found some hub adapters that work with the 114.3x5 BUT they are 20mm thick.
The wheel company said they are attempting to make them with an offset of 50.
Would this basically be the equivalent of running a 5mm spacer over stock?
I am still looking to run the 9.5" square setup.
All your help is appreciated as I only have one chance of getting these right.
Regards
|