Quote:
Originally Posted by Frenchstar-57
Hello, i confirm you that tape the tape in the hub is necessary, just one layer, and it must be homogeneous !
When i installed my new spacer, the spacer bore measured 66,6 and no play with the hub spigot of the car
however, before installing the wheel, i putted the spacer in the wheel and i could move the spacer into the wheel bore by my hand, because of the high tolerance.
So i put one layer of tape around the spacer spigot, then i putted the spacer into the wheel, it fit perfectly, no play and perfect centering (checked with feeler gauge) and then i installed the wheel, (with the spacer inside).
the results are concluants, no vibrations, just a short vibration at the speed of 140km/h but because i noticed it.
during this test, i doesn't used the mounting shaft and the frictions discs and the results are the same
|
Thank you, what kind of tape should i use?