[Junebug85]

I fitted some 50w CREE LED Pure White bulbs earlier and even coded out the bulb error warning message using BimmerCode.

I had to buy the UniCarScan OBD 2 device as my Vgate 3 wifi wss limited to what it can code on the G platform cars.

I looked through the modules but nothing was clear cut. I then went into expert mode and In the Body Domain Controller I found 3061. I remember this from when I coded the bulbs in my F30 335d.

Here's what I made Not Active:

3061 RFS_L_KALTUEBERWACHUNG = nicht aktiv
3061 RFS_L_WARMUEBERWACHUNG = nicht aktiv
3061 RFS_L_IS_LED = aktiv

3061 RFS_L_KALTUEBERWACHUNG = nicht aktiv
3061 RFS_L_WARMUEBERWACHUNG = nicht aktiv
3061 RFS_L_IS_LED aktiv

Coding successful and error gone! Even in daylight, they are quite bright