Quote:
Originally Posted by voltron1011
Instructions for venting cooling system:
1. Switch ignition ON (without starting engine)
2. Set heater to maximum temperature and turn fan down to lowest speed.
3. Press accelerator pedal for 10 seconds to floor. Engine MUST NOT be started!
4. The venting procedure is started when the accelerator pedal is pressed and takes approx. 12 minutes (electric pump was activated and shuts down automatically after 12 minutes).
5 Then top up fill level in coolant expancsion tank with 100ml above MAX line.
|
good start, but it seems that a few steps my be missing in your example, go deeper in your discussion!
