[SigmaPiFSC]

Hi Everyone,

I swaped out the hardware switch to add the Gentlemen control switch to control the passenger seat from the driver side in my 2023 530e (g30).

I saw a video on youtube showing to go into bimmercode and seat modual for driver and set Gentlemen switch to active. Then go into seat module passenger and do the same thing.

I did the first one for the driver, but there is no listing for seat module passenger, or anything similar.

So, does anyone have ideas or other videos? What am I missing? I uave bimmercode, bimmer utility, and protool, in case one of those will do the trick!

I do have a copy of Esys on an old laptop, but have not used it in a long time.
Any help is welcome!

Or, is this just not meant to be in a 2023 model? I noticed when I installed the replacement switch, that there is a space for an additional wire. Maybe a wire needs to be run? See the picture. But, the thing is, that the set, 1, and 2 buttons work, and when I push the button for seat 2, the LED light comes on. It just does not control the other seat yet.

[prettyuniquename]

Hey! Have you find the solution ?

[SigmaPiFSC]

Originally Posted by prettyuniquename

Hey! Have you find the solution ?

Sorry... no. I ended up putting back the original part. I think my passanger seat does not have the ability to be controlled remotly. It is a power seat, but I seem to recall determining it can't be done. But then again, I could be wrong. I just ran out of options. The part did fit, but... well... never could figure out how to make it work.

[zvery777]

Do you have the comfort seats? Check out the F10 forums, I believe I read something about this

[ezaircon4jc]

I don't remember totally, but I believe I successfully installed the switch in my few-options 2012 with the base seats. I can't seem to find the thread F10 forum. I would have done it around 2016...