03-15-2022, 04:39 PM | #1 |
New Member
0
Rep 11
Posts |
530e charging cable question
Can I use a standard extension cord and plug the occasional use charging cable into it?
I need to charge my car while it's in the driveway and the included cable isn't long enough. Thanks in advance! |
03-15-2022, 05:11 PM | #2 |
Colonel
2026
Rep 2,946
Posts
Drives: 2020 BMW 530xe
Join Date: Jul 2019
Location: Farmington, NY
|
You can, but as always with extension cords. Be careful to be sure the cord is rated to carry the load and is in good condition. Check it while running as well to be sure it isn’t hot especially by the connections where bends may have harmed the interior wiring.
|
Appreciate
0
|
03-15-2022, 06:26 PM | #3 | |
New Member
0
Rep 11
Posts |
Quote:
|
|
Appreciate
0
|
03-15-2022, 06:58 PM | #4 |
Colonel
2026
Rep 2,946
Posts
Drives: 2020 BMW 530xe
Join Date: Jul 2019
Location: Farmington, NY
|
Check the Occasional Use charger for the maximum rating it supports.
|
Appreciate
0
|
03-16-2022, 11:04 AM | #6 |
Lieutenant
242
Rep 535
Posts |
The max load for that EVSE is 10 amps--it's the same one I use. Get the shortest cord that will reach and ensure that it is at least 14 ga. wire. Lowes has a good selection of lengths in the 14 ga size. 12 ga is better, but generally unavailable at consumer outlets. The usual extention cords available at wall-mart/target, etc are 16 ga. This is marginal for a 10 amp load at lengths greater than 25'. If you have the skill, buy 12 ga wire of the correct length and make up terminals at both ends.
|
Appreciate
0
|
03-16-2022, 11:05 AM | #7 | |
New Member
0
Rep 11
Posts |
Quote:
|
|
Appreciate
0
|
03-16-2022, 12:01 PM | #8 |
Brigadier General
3086
Rep 4,210
Posts |
Ted 99 means "gauge". What he implied, but I want to make explicit for you, is that on wire the higher the number, the lower the capacity. So if 14 gauge would work for you, you can also use any gauge number lower than that but not any gauge number higher.
You might consider installing a charging station inside your garage if you have the ability to recharge during the day. On my 2018 530e, it took me something like 8 hours to fully charge the battery pack using the included 110 unit; on a 240 volt 20 amp line, I am getting a full charge from "0" or "---" in 1 hour and 55 minutes. In addition, most of those units come with a long cord (typically 25 feet) so you won't have to mess with nor be concerned about using an extension cord. |
Appreciate
1
ted99242.00 |
03-16-2022, 10:33 PM | #9 |
New Member
11
Rep 23
Posts |
Remember, too, that you can adjust your charging current in iDrive. With that 10A charger, you have the option of 10A, 7.5A or 6A charging current. Those lower ratings might be something to consider if you can’t get a good quality high current extension cord, or if you notice any of the cord plugs getting unreasonably warm. Of course, the reduced current means longer charging times.
See: My Vehicle - Plan charging/climate control - Charging rate settings. The car comes from the factory set to the lowest setting. |
Appreciate
0
|
03-17-2022, 10:13 AM | #10 |
Lieutenant
242
Rep 535
Posts |
I moved from a place where I had a Level 2 EVSE to a retirement home where a 110v. outlet was the only choice--and I felt lucky to get even that. Fortunately, we drive once a day, at most, and the 10 amp Level 1 EVSE provided with the car has sufficed to give me a 100% charge between uses. So, the Level 1 EVSE CAN be a solution in these times of reduced driving for some.
|
Appreciate
0
|
03-17-2022, 10:46 AM | #11 | |
Brigadier General
3086
Rep 4,210
Posts |
Quote:
|
|
Appreciate
1
ted99242.00 |
03-17-2022, 10:46 AM | #12 | |
Captain
644
Rep 629
Posts |
Quote:
__________________
2019 540xi M Sport, Carbon Black/Cognac, 2014 328xi, 2016 Corvette Z06; Previous:2010 BMW 535xi M Sp, 2008 335xi, 1998 M3 Sedan,1980 528i, 1977 320i, 1976 2002
|
|
Appreciate
2
ted99242.00 SteveinArizona3086.00 |
03-18-2022, 10:55 AM | #13 |
Lieutenant
242
Rep 535
Posts |
To put the current draw from the Level 1 EVSE is perspective, 10 amps is 1100 watts, or about the same as an iron on high or a space heater. It's close to the practical maximum from the common 15 amp wall outlet in homes. Electrical code prescribes that steady-state draw from an electrical load should be no more than 80% of the breaker size or outlet rating, whichever is less. If a house has been wired with 14 ga. (gauge) wire--which is common for spec built developments--the breaker should be 15 amp and the outlets will be rated for 15 amps. 80% of 15 amps is 12 amps. If a house has 20 amp 110v. breakers, it has probably been wired with 12 ga. wire, but the outlets may still be 15 amp rated. One needs to examine the back of the outlet to determine it's current rating. The "best" outlet to use for a high-current load is a "Hospital Grade" outlet, which has a 20 amp rating and tighter grip on the plug prongs. These are available at Home Depot/Lowes. It used to be that they were always orange colored, but you can now get them in more colors from Amazon. They always have a green triangle on the front of the outlet. It's also easy to get 20 amp "heavy-duty" outlets in the home stores. They will have the higher current rating but not the advanced grounding features and tighter grip of the hospital grade outlets.
On a side note, in the Audio/visual gear forums I participate in, the occasional poster comes up with a question about whether the big dollar fancy power cords are worth it. My reply is that one should invest $20 in a hospital-grade outlet instead--it will actually improve things. A 4' fancy power cord at the end of 50 feet of Romex house wiring cable is unlikely to add any value. |
Appreciate
1
Warp Ten643.50 |
03-18-2022, 12:38 PM | #14 | |
Colonel
2026
Rep 2,946
Posts
Drives: 2020 BMW 530xe
Join Date: Jul 2019
Location: Farmington, NY
|
Quote:
|
|
Appreciate
1
ted99242.00 |
03-18-2022, 05:15 PM | #15 | |
Brigadier General
3086
Rep 4,210
Posts |
Quote:
|
|
Appreciate
2
LogicalApex2025.50 ted99242.00 |
Post Reply |
Bookmarks |
|
|