05-02-2023, 02:04 PM | #1 |
Private
39
Rep 56
Posts |
2018 M550i engine replacement
Hey all, it’s been a while. I posted on here over a year ago when my g30 m550i ran into some issues.
Long story short, somehow two of the eight cylinders got scratched on the inside and essentially the car needed a new motor and it was out of warranty. I went through a whole process and a lot of back and forth with bmw Canada and they said the best they can do is $45,000$ CAD all in for a new motor and labor etc and they informed me that it could run higher than that once they start the process and find out if they need to swap any other parts etc. I sat on it for 6 months and was going to pull the trigger on it but they demanded I pay 45,000$ in advance and leave my car with them before they will even order the engine from Germany (No finance, no loaner car). I didn’t go through with it and drove my 750i and the m550 sat in my garage for a little over a year. I ended up sourcing a used engine off a 2019 750i (same N63 block) as I needed just the core and all other parts were going to be from the m550. The engine was $14,500$ with 75,000KM. Did a full inspection and compression tests and it was sound. I got the engine replacement done by a local highly reputable BMW specialist shop and they estimated 6-9,000$ for the labor and extra parts. Upon starting the job they realized a lot of the lines and connectors were upgraded from 2018 onwards and to be safe I decided to get the new upgraded stuff to avoid leaks and issues further down (the integrity is compromised after removing and reinstalling hoses and connectors IMO). During the process they found the front left CV shaft had damage($2,500$ part), the SZL module was bust (responsible for indicators and wipers, $2000 part, as if bmws even need indicators) and a couple other minor things. I just got the car back yesterday and it drives like a beauty. The labor and extra parts cost $16,000. All in I spent 30,000$ cad to get this baby back on the road. It’s a lot of money but she’s my special baby so I had to fix her up. I wasn’t even wanting to get a different m550 as this car is sentimental to me. Thought I’d share the experience on here with everyone. |
Appreciate
8
|
05-02-2023, 03:34 PM | #2 |
Lieutenant Colonel
1303
Rep 1,626
Posts |
Wow...how many miles on your original engine when it failed?
__________________
2020 M550i (G30) | Carbon Black/Black Nappa | DHP | DAP | Executive | Luxury Seating | Park Asst | Ceramic Controls | Front/Rear Heated Seats | 20" 668M wheels
2021 X3 (G02) | Dark Graphite Metallic/Cognac | Premium | DAP | Front/Rear Heated Seats Sold/Retired: 2012 328i (F30) |
Appreciate
0
|
05-02-2023, 03:39 PM | #3 |
Private
39
Rep 56
Posts |
The original motor had 87,000km. No tune, pretty much stock besides a dinan exhaust. I heard knocking sounds and thought maybe it was rod knock. They tested the oil and there was no traces or metal or anything. Had to take the car apart and use a camera to check inside the cylinders to determine the cause. Car was still running but sounded horrible with the knock and was essentially a ticking time bomb.
|
Appreciate
0
|
05-02-2023, 03:52 PM | #4 |
Colonel
2026
Rep 2,946
Posts
Drives: 2020 BMW 530xe
Join Date: Jul 2019
Location: Farmington, NY
|
Glad it is all sorted. Yikes on the road and a new motor that young!
|
Appreciate
0
|
08-13-2023, 10:13 PM | #6 | |
Lieutenant
138
Rep 523
Posts |
Quote:
|
|
Appreciate
0
|
08-14-2023, 09:01 AM | #7 |
Captain
644
Rep 629
Posts |
Sounds like you made the best of an otherwise bad situation. Glad you had a good BMW specialist in your area. We have one in our area but not everyone does. Hope you get to enjoy it for a long time. --Bob
__________________
2019 540xi M Sport, Carbon Black/Cognac, 2014 328xi, 2016 Corvette Z06; Previous:2010 BMW 535xi M Sp, 2008 335xi, 1998 M3 Sedan,1980 528i, 1977 320i, 1976 2002
|
Appreciate
1
Joe-BMW337337.50 |
08-15-2023, 04:14 PM | #8 |
Colonel
1796
Rep 2,997
Posts |
How on earth did you have a visibly scratched cylinder and it wasn't showing up in the oil?!?!
__________________
AW/Carbonstructure 6MT 2015 M3 picked up 8/22/2014. Stripper except for adaptive suspension. Weighed at 3,450 pounds with 1/4 fuel. 70,000 miles as of February 2020.
|
Appreciate
0
|
08-15-2023, 04:24 PM | #9 | |
Private
39
Rep 56
Posts |
Quote:
This was done by the specialist shop, they then used the bore scope and checked the cylinders to find the scratches. The car was then put together and taken to BMW where they confirmed the issue but could not pin point what would cause that. Never had aftermarket parts except for the NgK sparks. A lot of people suspected various different possible scenarios of where the noise could be from but it was a very unexpected thing that nobody guessed. The cad still ran fine but the noise got worse with time |
|
Appreciate
0
|
08-15-2023, 04:26 PM | #10 |
Private
39
Rep 56
Posts |
|
Appreciate
0
|
08-15-2023, 04:27 PM | #11 | |
Private
39
Rep 56
Posts |
Quote:
My 7 series has been quite amazing, only been in the shop for a busted air bag on the air suspension. |
|
Appreciate
0
|
08-16-2023, 07:08 PM | #12 |
Grumpysaurus Rex
484
Rep 423
Posts
Drives: 2022 M550i
Join Date: Jan 2020
Location: San Diego, CA
|
I thinks it's cool that you had the means and motivation to fix it; if you wanted it and could do it, why not? Cheers!
__________________
“Science has made us gods even before we are worthy of being men.”
|
Appreciate
0
|
08-16-2023, 09:45 PM | #13 |
Enlisted Member
38
Rep 30
Posts |
Your BMW dealer in Calgary is apparently as helpful as the one in Oakville, ON. Certainly not as extreme, but I have painting flaking off my 2018 540i and they now don't want to know me.
|
Appreciate
0
|
08-17-2023, 07:57 PM | #14 | |
Private
39
Rep 56
Posts |
Quote:
He told me the engine was ordered from Germany. 2 weeks later he said it wasn’t ordered they need me to tow the car to the dealer before they can ship it. I towed the car there and 2 weeks later called for an update and they told me that my rep has changed and I had to explain everything all over again only to find out that the engine still was not shipped and I had to pay a minimum of $33,000 upfront before they can ship it. |
|
Appreciate
0
|
08-17-2023, 08:14 PM | #15 |
Captain
450
Rep 675
Posts |
This is the post that causes me to not get a tune! I still have two years on my certified preowned warranty …. $45k for a motor replacement … ouch!
__________________
Sean
2016 X5 sDrive 35i 2018 M550i |
Appreciate
0
|
08-18-2023, 11:16 AM | #16 |
Colonel
1796
Rep 2,997
Posts |
I'm not an n63 expert, but there's a few things here about Ops experience that bear calling out:
- It is unknown what scratched his cylinder walls. They get scratched from metal falling into the cylinder either from something coming in the intake, valves breaking, spark plugs breaking, or rings breaking. The fact he was using non-BMW spark plugs introduces a few possibilities - a bad spark plug, something falling into the cylinder during spark plug replacement, etc. - The story is that the cylinders are scored but not showing up in oil - either visually or in oil testing. This would be unusual. - His engine is before they moved to plasma arc sprayed. I am unclear why the cylinder couldn't be repaired, but again, not an n63 expert. ...... Total engine replacement is only needed in very rare circumstances and it is unclear why it was necessary in this instance. I'm not saying it wasn't necessary; just that this does not fall into the traditional category of "n63 stories"
__________________
AW/Carbonstructure 6MT 2015 M3 picked up 8/22/2014. Stripper except for adaptive suspension. Weighed at 3,450 pounds with 1/4 fuel. 70,000 miles as of February 2020.
|
08-18-2023, 12:58 PM | #17 |
Major
1003
Rep 1,127
Posts
Drives: G30 M550i
Join Date: Oct 2016
Location: Toronto
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
engine replacement, engine swap, g30, m550, n63 |
|
|