11-16-2018, 01:33 PM | #1 |
Registered
1
Rep 2
Posts |
Tpms Module
Hello,
I just installed TPMS sensors on my car but not working before I had only normal valves. Do I need to install any modules or recode the car to solve the problem ? VIN: WE63658 Thanks in advance |
01-07-2019, 02:23 PM | #2 |
Lieutenant
64
Rep 407
Posts |
You definitely need to recode. I will be doing this soon and was hoping someone would know which modules would need to be recoded. I am sure HU_NBT and KOMBI would be part of it.
__________________
|
Appreciate
0
|
01-08-2019, 01:36 PM | #3 |
General
12916
Rep 18,685
Posts |
If the procedure is still the same.
You'll need to add 2VB in the VO, then code HU_NBT, BDC_Body, DSC, Kombi. Some of the modules may have different name, but it shouldn't be far off from the original name.
__________________
Email:sales@rgsport.com | IG:RGSport_USA | Web:RGSportShop.com PM for Everyday DEALS!! MSS • iSweep • RaceChip • Sterckenn • AutoTecknic • Akrapovic • Vossen Wheels • Eventuri Active Autowerke • KW • H&R • Ohlins • Remus • and more... |
Appreciate
0
|
05-02-2019, 04:50 PM | #5 |
Enlisted Member
1
Rep 34
Posts |
Guys, just to jump in with additional question here.
My car, which has tire pressure monitor, came with 759i rims and all works perfectly. I am going to use 662M for winter wheels, thus I bought a new pair of RDCi sensors which will be installed on the winter wheels, and question here is what should I do so I would get the car to pick up the single from the new sensors. Additionally - do we have to do something to put the not used sensors to "sleep" as I have been reading that all of them have batteries which will expiry at some point. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|