10-12-2021, 04:28 PM | #1 |
Private
28
Rep 65
Posts |
How to remove the OEM hose clamps (E90)
How and the heck????
How to remove those suckers without damaging the OEM hose, that is the dilemma. Any folks with high EXP on those much welcome to comment. Thanks, Chef |
10-13-2021, 05:59 PM | #5 |
Private
28
Rep 65
Posts |
|
Appreciate
0
|
10-13-2021, 06:04 PM | #6 | |
Private
28
Rep 65
Posts |
Quote:
I upgraded that part to the Aluminum version for reliability. (pic shown but mine is aluminum in color as well) |
|
Appreciate
0
|
10-13-2021, 06:05 PM | #7 |
Private
28
Rep 65
Posts |
|
Appreciate
0
|
10-13-2021, 06:18 PM | #8 | |
Brigadier General
3956
Rep 3,996
Posts |
Quote:
__________________
|
|
Appreciate
1
POBEP374.50 |
10-14-2021, 01:13 PM | #9 |
2018 M3 ZCP / 06 330xi
211
Rep 278
Posts |
Changed my Mickey Mouse flange out and have had zero problems. Just make sure you clamp off the hose about 6" down so nothing goes down in there. Absolutely no need for a new hose. 200k miles and still rolling.
|
Appreciate
0
|
10-14-2021, 03:08 PM | #10 | |
Private
28
Rep 65
Posts |
Quote:
Smart man on the clamp off, I notice that immediately that there could be an issue with dirt or worse dropping in that hose. Thanks for the vote, the OG hose looks fine and was probably replaced at some point, looks newer...so I am going to stick with it. Also, I use the 'Mickey Mouse' saying too, hilarious! |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|