[OneSon]

I recently had a problem with my Satnav and voice command whereby the Satnav was greyed out and the voice command was none responsive to actions.

Those issues were resolved by a third party who advised that my FSVC codes were deleted. He fixed the issue using OEM codes.

Anyway since then I haven't been able to access the Head Unit when I code the car using Bimmercode. I keep getting an error messaging saying that "head unit not in original state".

I am seeking assistance from the forum on two main points.

1. Is there anyway I can bypass the error code or remedy the issue?

2. Would Carly allows me to code the head unit in its current state?

I look forward to your replies.
Many Thanks

[kubax86]

Originally Posted by OneSon

I recently had a problem with my Satnav and voice command whereby the Satnav was greyed out and the voice command was none responsive to actions.

Those issues were resolved by a third party who advised that my FSVC codes were deleted. He fixed the issue using OEM codes.

Anyway since then I haven't been able to access the Head Unit when I code the car using Bimmercode. I keep getting an error messaging saying that "head unit not in original state".

I am seeking assistance from the forum on two main points.

1. Is there anyway I can bypass the error code or remedy the issue?

2. Would Carly allows me to code the head unit in its current state?

I look forward to your replies.
Many Thanks

Best way is to use E-Sys.
1. Without PC and ENET cable - no
2. From my knowledge - no

[OneSon]

Much appreciated. I need to master the art of e-sys going forward.

[NesoX]

you cannot code if your HU is not in its original condition