[JSKS76]

Hi folks. Trying to understand how to install the front lip. From the instructions, it looks like the front plastic piece on the bottom (front engine shield/air guide) that the bumper cover bolts onto needs to be removed (so that the front lip can be bolted onto the bottom of the front bumper cover). Am I reading this correctly? Let me know, thanks.

[JSKS76]

What I don't get is how am I suppose to fasten the bolts? From the diagram it looks like the left and right splash guard is still in place, or am I reading it wrong and the left and right splash guards comes out too?

[tjbuggy2b]

I found it helpful to remove the center front underbody skid.
However, I only needed to detach the front hardware for the Front Corner Underbody Aero Covers.

You might also find this review I did helpful if you run into issues with the hardware not being long enough. Keep in mind, I ended up only installing the lip, not the side splitters. So, if you wind up needing longer hardware, you might need even longer screws than what I bought.