02-24-2024, 03:20 AM | #1 |
Registered
0
Rep 1
Posts |
G30 HK with RAM - upgrade
Hi there, I'm new to this forum and did the search but with no help...
The point is to upgrade my G30 with factory installed HK (RAM) to Helix v12 / Match up 10bmw. Helix V12 already installed and connected between HK amp and speakers by High Level output using modified Match cable (HK RAM) - connector at Amp end cut off as v12 only accepts clear wires. At other end the harness goes to stock BMW connectors. Underseat midwoofers replaced with 4 Ohm units. Speakers not yet replaced. I've taken the file for Match up10bmw with HK-RAM from auditech-fisher site (for helix not offered) and all the settings there are zeros i.e. it seems if it's fully requlated by the HK. My understanding is that the signal going out of HK is already HP / LP filtered and it should be different from channel to channel. Additionally delays partly involved. So wondering if anyone is able to clarify: 1) frequency range going out of HK per every channel 2) delays set per channel 3) is it possible to take unprocessed signal 4) if HK given B&W coding, would that be possible to get unprocessed signal 5) Anyone willing to share the settings for Helix / Match 6) What do you guys do to solve this ...Recently there was a Ethernet->Toslink adapter offered by the Chinease but it's around 900 USD so I'd rather to stay away from that just now. Appreciate any advice |
Post Reply |
Bookmarks |
|
|