[hart07]

hello evrybody i would like to buy and fit a front lip on my 520d msport.
i would like to buy this one :
https://www.dm-autoteile.de/Frontspo...t85ffqk7g_hCP8

or this one on ebay :
https://www.ebay.fr/itm/304232277931...b4ba%7Ciid%3A1


But need to know how to fit it :
i need an hand drill + drill but what mm ?
and need screws too
thks

[johnnyp420]

It looks like the kit you referenced comes with self tapping screws.

I don't remember what size drill bit I used but I made sure it was much narrower than the screws that came with the kit. If I had to guess the bit size I used was 1/16 or 5/64. You just want to make a small enough hole to where you aren't fighting with the screw when screwing it in the bumper. You also want to make sure you use a low torque setting on the drill so you don't strip the holes.

[hart07]

Originally Posted by johnnyp420

It looks like the kit you referenced comes with self tapping screws.

I don't remember what size drill bit I used but I made sure it was much narrower than the screws that came with the kit. If I had to guess the bit size I used was 1/16 or 5/64. You just want to make a small enough hole to where you aren't fighting with the screw when screwing it in the bumper. You also want to make sure you use a low torque setting on the drill so you don't strip the holes.

thks a lot
yes low torque but the size drill should be 1.5mm or 0.5 mm
and what kind of screws to fill the holes ? its sell with the front lip ?
yes tape is for the corner

[hart07]

Any help please

[rvkrn]

have you successfully fitted this? was this easy to fit?

[hart07]

No I am looking for thread or videos to fit it on my g30
I want to buy the front splitter as you see on eBay.

[hart07]

Any help please
I would like to know how to fit the lip I saw the two corners sides have to be fix with double side tape ( need to heat the double side tape for a better fixation)
But regarding the lip I need to screw the bumper or there are holes in the bumper and just need to drill the lip before to screw the bolts
Thks for your help

[spiciercheez]

If I remember correctly, there are two predrilled holes on the ends of the bumper that should help you to line up the lip. After that you would have to drill through the lip and bumper to secure it in the middle.