02-17-2024, 03:36 PM | #1 |
New Member
0
Rep 8
Posts |
Missing HC2 module in Esys
Hey folks,
I have a G31 fitted with 5AT (Driving Assistant Plus) and I replaced two of the front lane change sensors. Afaic, I have to program the new sensors to fit on my vehicle (I am getting an error in ISTA, something on the lines of "SWW Lane change sensor: Slave missing"). I tried to open up esys to code the module to default values, but I don't see any HC2 there. Am I missing something? Is there any other procedure for replacing lane change sensors? The ones that I am trying to install come from another vehicle. Thank you. |
02-17-2024, 06:40 PM | #2 |
Lieutenant
136
Rep 525
Posts |
Use tool32 to open and reset flexray port and then code hc2 with esys
__________________
Successfully retrofit on BMW F30 335xi 248,302,3AG,430,5AG,5AS,6NS,8TH and IHKA3
|
Appreciate
0
|
02-18-2024, 02:46 AM | #4 |
Lieutenant
136
Rep 525
Posts |
In tool32 start ZGW_01.prg
steuern_flexray_pfad ==>0x03;0x01==>F5 steuern_reset_learn_flexray==>F5
__________________
Successfully retrofit on BMW F30 335xi 248,302,3AG,430,5AG,5AS,6NS,8TH and IHKA3
|
Appreciate
0
|
02-18-2024, 04:13 AM | #5 |
New Member
0
Rep 8
Posts |
thanks, I've tried that, but HC2 still not showing up in esys
also, I have tried flexray init in ista, but it was not succesful and now I have a ZGM error as well in ista. am I missing something? |
Appreciate
0
|
02-18-2024, 04:56 AM | #6 | |
New Member
0
Rep 8
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
coding, driving assistant plus, esys, g30, ista, lane change warning, troubleshooting |
|
|