[YV1]

I changed the radio on my E90 2006 325. Same model number, same radio. It's a HIFI basic unit. I tried to code the new radio ( 2URAD module ) with NCS expert. After coding, the radio won't turn on. Even the clock is off, it doesn't light up. I ran INPA and it shows : ERROR_ECU_GENERAL_REJECT. I reinstalled the old radio ( one channel is fried ) and it works ok. So it's not the car or any fuses. I also check the fuse on the back of the radio.
My NCS expert is old and I'm using old daten.

Can this be a coding problem? or I just fried the power unit of the radio? I'm already working on getting a newer NCS and daten, but I don't want to waste my time trying to fix it with software if it's a hardware problem. Should I get a new radio? or keep trying with this one?

Also, I have to code the VIN number of the car in the radio. How can I do that? I know it 's possible with FGNR_SCHREIBEN job. But I don't know how to run this job. The VIN is not on the 2URAD data.

[ctuna]

Never heard of this before .
Were you able to read the radio file before you attempted
to reprogram it.

You might try these guys(following link) or Bimmertech for help.

http://beckerautosound.com/

[YV1]

I can read the radio file. I can change the data and code. But radio won't come out of the sleeping mode.

[matteblue3er]

Try pushing SG_Reset to the radio with ncs.

[wildcatcrazy]

Originally Posted by esteller

I can read the radio file. I can change the data and code. But radio won't come out of the sleeping mode.

Also may try finding someone with an ICOM and flash it.

[YV1]

I tried SG_reset, didn't work. I going to take to a BMW local shop. They'll try with ICOM. Thanks for the help!!!