01-24-2017, 05:53 AM | #1 |
Captain
260
Rep 955
Posts |
JB4 - Fuel rail connector recommended to be plugged in?
So when I did my JB4 install, I had a single connector left over unplugged.
Its the flexfuel connector. As many recommend, since I live in a country where flexfuel is not available, I left it unplugged. Plus to top it off I couldn't figure out where it plugs in... Most of the DIY guides omit it. I now know where it connects. Deep-ish under the foam padding, which most likely will need to be taken out to get to it. So my question is: Is this connector used AT ALL on Map1 / Map2 / Map5 / situations where flexfuel is not used? Thanks! PS : Lol, of course when I google it now... The install guide (PDF) comes up first result haha... http://www.burgertuning.com/instruct...el_Install.pdf |
01-24-2017, 09:12 AM | #2 | |
BimmerPost Supporting Vendor
4920
Rep 115,999
Posts |
Quote:
What gas are you using and what mods on the car? If just using pump gas its not really needed. Mike |
|
Appreciate
0
|
01-24-2017, 11:46 AM | #3 |
Captain
260
Rep 955
Posts |
|
Appreciate
0
|
01-24-2017, 01:59 PM | #4 |
BimmerPost Supporting Vendor
4920
Rep 115,999
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|