01-28-2019, 11:46 AM | #1 |
Captain
284
Rep 912
Posts |
2015 F25 - Chrome Fender Side Finishing Panels
Better half comes in the door saying the drivers side panel is missing again...that’s the second drivers side...we have also lost one on the passenger side. Until last night, I thought they may have been stolen...at 80 bucks Canadian each...
All previously replaced by BMW. She had just come from a touchless car wash...so thought take a look, you never know. Broken part found blown against wall in car wash bay. These things are total Chinese junk... the tabs are absolutely crap. I doubt that the dealer will replace under our CPO warranty which has just kicked in. In Europe they have side indicator lights in that spot... I ordered two and expect them to be far more robust.... Anyone else had these come off at a car wash or elsewhere? Last edited by Bilbofraggins; 01-28-2019 at 02:15 PM.. |
01-28-2019, 04:18 PM | #2 | |
Private
20
Rep 66
Posts |
Quote:
|
|
Appreciate
0
|
01-28-2019, 04:36 PM | #3 |
Captain
284
Rep 912
Posts |
I guess the weather 10 hours north is a bit harder on cheap plastic...
I do plan on covering them in future when she goes through the wash with tape...I just put this busted one back on with 3m....not the greatest time at -15C This is what is going in next time: https://www.amazon.ca/dp/B01BNR72I6/...800_TE_3p_dp_1 |
Appreciate
0
|
01-30-2019, 03:21 PM | #5 |
Captain
284
Rep 912
Posts |
Oas, Gotcha...if they fall off again, the lights above are going in as filler...I doubt there is a connector to hook them up either way in our vehicle.
|
Appreciate
0
|
01-30-2019, 04:50 PM | #6 |
Second Lieutenant
278
Rep 280
Posts |
|
Appreciate
0
|
02-05-2019, 11:56 AM | #7 |
Second Lieutenant
86
Rep 268
Posts |
AS you replace the base, clean fender and put a small bead of silicone caulk
around, and very close to the hole edge in fender. Then the same around the base and lense. This will reduce vibration, and water intrusion around both. To make the caulk fill and smooth out so you can barely see it. Apply caulk then spray with window cleaner, you finger or plastic tool will glide easily over the silicone. You can apply painters tape too ....if needed for sharp edges Sorry this has to be done when area applied is warm ! Also needs to dry.
__________________
2017 BMW X3 x28i SOLD
2015 Honda CRV-EXL AWD 2019 Honda CRV-Touring AWD 1965 Chevrolet Corvette 327 / 4spd Convt |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|