|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Tank Breather Valve O-ring Replacement
|
|
12-02-2019, 08:33 AM | #1 |
Private
30
Rep 71
Posts |
Tank Breather Valve O-ring Replacement
Does anybody have a good source for the rubber o-rings that are used for the tank breather valve pipes. See picture below. It is a 12 mm o-ring. Mine packed out a bit over time, causing a minor tank evap leak.
|
12-02-2019, 05:15 PM | #2 |
Private
30
Rep 71
Posts |
Turns out Rockauto send me a "broken new vapor canister purge valve". I put the old one back. When you blow on the valve intake it allows air through. That should not happen. Lesson for everybody: Check whether the valve seals before you put it in. Or check any part for that matter for good behavior when possible..... Ugh.
|
Appreciate
0
|
Bookmarks |
|
|