|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Base Audio- How to Remove Subwoofers?? Glued in!
|
|
10-22-2020, 12:06 PM | #1 |
New Member
4
Rep 20
Posts |
Base Audio- How to Remove Subwoofers?? Glued in!
Hi All
I picked up a pair of L7 Subwoofers to replace the base crap Subs. I removed the seat smoothly, got the grill off etc however the speakers are near impossible to remove! From what I gather the L7 were screwed into the enclosure, however the Base subs do not have any screws, just a couple of tabs holding it and will not budge! I can only assume they are glued in, but does anybody have a trick into getting these suckers out? Thank you so much in advance! |
10-22-2020, 01:01 PM | #2 |
Lieutenant General
1911
Rep 13,104
Posts |
Yes they are glued in . Go Gorilla.
https://f30.bimmerpost.com/forums/sh....php?t=1406775 If you have a base system they may not work due to the parallel connection with the doors. Last edited by ctuna; 10-22-2020 at 01:10 PM.. |
Appreciate
0
|
10-22-2020, 03:42 PM | #3 | |
New Member
4
Rep 20
Posts |
Quote:
I plugged in the L7, and I did get some action from them so they do work! I forgot to plug the base sub back in, so now my right speaker (door) is also not working! Need to do it again this weekend and rip that sucker out! |
|
Appreciate
0
|
10-22-2020, 06:02 PM | #4 |
Lieutenant
354
Rep 511
Posts |
Get a slightly oversize screw that is just large enough to screw into the subwoofer mounting hole. Screw it in a few millimetres and then pull hard.
|
Appreciate
0
|
10-22-2020, 11:37 PM | #5 |
New Member
4
Rep 20
Posts |
|
Appreciate
0
|
10-23-2020, 10:56 AM | #6 | |
New Member
4
Rep 20
Posts |
Quote:
I plugged in the original sub again, and both sub and speaker did work. My guess is that I need to code the HU, which I guess I can look into. Could i do it with Bimmercode app? |
|
Appreciate
0
|
10-23-2020, 04:30 PM | #7 |
Lieutenant General
1911
Rep 13,104
Posts |
It won't do you any good to code it .
Coding it to Hi Fi drops the outputs of the stock system, to 5 volt pre outs. If you have an aftermarket head unit is does nothing. You need at least a 4 channel amp and you have to split the parallel connection between the doors and floors and run each location on it's own channel. You need to reread all those posts I put up about the base system many times over. http://www.e90post.com/forums/attach...5&d=1493273253 Last edited by ctuna; 10-23-2020 at 04:51 PM.. |
Appreciate
0
|
Bookmarks |
|
|