[Donald-335i]

BIMMERPOST / Classifieds

Asking Price:

None

Item Interest

One Perfect JB3 With

Gen2 Unlocked 18ohm Board With The final 1.4 chip

Gen1 Board With The 1.4 R8 Beta Chip *this took me to 11.9*

All Included for $375 + swap at nj323ci

$400 Shipped Via Paypal.


switching to procede for the meth kit..

[Jonny550]

switchin to the dark side ahh.......GL wts

[onefastman]

PM sent!

[BimmerBlack11]

is it the pnp?

[Terrance28]

You planning on being the first procede customer in the 11s haha.

[Mike@N54Tuning.com]

Hi Larry,

You can use the Vishnu meth kit or any meth kit with the JB3. With the G2 board it's really easy, just hook your failsafe wire up to the map switch port on the harness and then you can setup the JB3 to switch over to a race map when the meth is on, or switch off a race map when the meth is off, depending on your needs. Depending on whether it pulls a signal to ground or pulls the signal high you may need to add
a resistor as well to the harness.

Either way though one of those boards was supposed to be returned to BMS. They sent a spare rather than having you send yours in to save you the down time...

Mike

[Jonny550]

Originally Posted by Mike@N54Tuning.com

Hi Larry,

You can use the Vishnu meth kit or any meth kit with the JB3. With the G2 board it's really easy, just hook your failsafe wire up to the map switch port on the harness and then you can setup the JB3 to switch over to a race map when the meth is on, or switch off a race map when the meth is off, depending on your needs. Depending on whether it pulls a signal to ground or pulls the signal high you may need to add
a resistor as well to the harness.

Either way though one of those boards was supposed to be returned to BMS. They sent a spare rather than having you send yours in to save you the down time...

Mike

Listen to the man don their is a reason the jb3 took n54 to the lowest numbers ever recorded.