|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
BMS powerbox installation help
|
|
10-02-2010, 09:57 AM | #1 |
Private
3
Rep 93
Posts |
BMS powerbox installation help
Weird Buzzing sound from ECU box once I re-insert the smaller connector into the ECU (when i push the slider back in) this is the step before connecting PBX box to the harness on page 26 of installation guide.
Any idea what this buzzing is? I disconnected the connector to avoid the sound. I will re-check all the connections tomorrow morning. Just wondering if anyone experienced something similar? I have a 325 2.5l (EURO/Asia spec).. I noticed for the Small grey sub connector my pin 7 is actually white with yellow stripe rather than plain white as stated in the instruction manual. O_o does this matter? Manual says: "Small gray subconnector: PBX yellow - pin 7 (white)" Hope I didn't fry anything. update: fixed it. the problem was i put the grey/black subconnector in the wrong slots (black in grey and vice versa) (even though i thought it was impossible.. i managed to do it that way) thus they were stuck in there. pain in the a$$ to get back out.. for people installing on your own.. don't rush and don't force anything in. Last edited by ispeedyi; 10-03-2010 at 12:00 AM.. |
10-02-2010, 09:22 PM | #3 |
Private
3
Rep 93
Posts |
Any ideas what the buzzing sound is?
i have re-checked all the wiring but can't get the black and grey subconnectors out again (they seem to be stuck in the ECU holder) |
Appreciate
0
|
Bookmarks |
|
|