|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Injen intake install problem
|
|
10-25-2010, 05:02 PM | #1 |
Second Lieutenant
26
Rep 257
Posts |
Injen intake install problem
Hey i pretty much have everything installed correctly and the coupler going on to the throttle body keeps popping off when it gets tight i drove it around for a few after i finally got it to stay on and now i checked it and its off i dont know what to do..any ideas?
|
10-25-2010, 05:20 PM | #3 |
Second Lieutenant
26
Rep 257
Posts |
i did that and it felt like it was on i pulled on it and it didnt come off went for a drive to test it out checked it and it came off the throttle body again
|
Appreciate
0
|
10-25-2010, 08:43 PM | #5 |
Lieutenant
47
Rep 486
Posts |
i had this problem during install, but i just muscled it over the throttle body by widening it with my fingers and stretched it around, like a rubber band. then i went ahead and put the band over it and tightened it real good
__________________
FOR SALE - 2014 Scion FR-S 6 spd, 27,000 ODO $17k pm me
2010 e92 Mojave Metallic - farewell old friend /2013 2015 435i xDrive Gran Coupe Sparkling Brown | Cocaine White interior | JB4 | BMS Intake | Wagner Intercooler Evo I | VRSF Downpipes | ER Chargepipes |
Appreciate
0
|
10-26-2010, 08:10 PM | #7 |
Lieutenant
47
Rep 486
Posts |
the bend in the intake pipe makes it tricky to make it fit snug against the coupler. just make sure it fits perfectly in the inner ring stop and it should be fine
__________________
FOR SALE - 2014 Scion FR-S 6 spd, 27,000 ODO $17k pm me
2010 e92 Mojave Metallic - farewell old friend /2013 2015 435i xDrive Gran Coupe Sparkling Brown | Cocaine White interior | JB4 | BMS Intake | Wagner Intercooler Evo I | VRSF Downpipes | ER Chargepipes |
Appreciate
0
|
Bookmarks |
|
|