05-11-2014, 07:32 AM | #1 |
Lieutenant General
5886
Rep 10,256
Posts |
Front PDC sensor: beeping red (nothing ahead)
My 2013 F30 335i xDrive has been trouble free for over 1 year (SA build).
During the last 2 weeks, the front PDC sensor developed unexpected symptoms. There are no obstructions ahead of the vehicle. 1. Start the car. Sensor beeps red (continuous sound), red bar is rendered in front of the vehicle (on the screen). 2. Shift to Drive, begun moving slowly. Still beeping, red bar is still rendered. 3. Accelerate. Beeps frequently, but not continuously anymore. 4. Stops beeping after few hundred yards. The car is at the dealer right now. The dealer is also performing several factory recommended service procedures, nothing mechanical as I understand. One of them is the water drainage grommet replacement. |
05-11-2014, 08:27 PM | #2 |
Private
2
Rep 67
Posts |
Dirty sensors?
__________________
2014 335xi | Luxury | Technology | Imperial Blue Metallic | Saddle Brown Dakota | Driver Assist Plus | Cold Weather | Active Cruise Control | Harman Kardon
|
Appreciate
0
|
05-11-2014, 10:58 PM | #3 |
Now in the dark side !
65
Rep 1,136
Posts |
^This.
__________________
Present: 2011 Porsche Carrera S Cab, white (Now on the dark side!)
BMW X3 M40i (wifey) Past:2012 335i Sport Black, 20" 356 wheels, M Sport Aero, MPE (Sold -kinda missed) 2010 X5 35d Black fully loaded (Sold) 2007 335i sedan Antracite (Sold and missed !) |
Appreciate
0
|
05-12-2014, 04:37 AM | #4 |
Lieutenant
73
Rep 564
Posts |
Happens a lot during the winter months if there is snow/ice stuck to the bumper. Assuming none of that is present at the moment so probably just dirty?
__________________
F30 328i M Sport +
Twitter: @3qtrsamericano |
Appreciate
0
|
05-14-2014, 06:58 AM | #5 |
Lieutenant General
5886
Rep 10,256
Posts |
Update after my dealer performed the service
- PDC sensor was faulty but not the front one. The rear sensor recorded the fault. Unusual because iDrive screen was showing a front obstruction. - Three service campaigns have been performed B71 01 13 Replace Emissions Label, B51 05 14 Remove Water Grommet and B51 06 14 Rework Corrosion Protection. |
Appreciate
0
|
05-15-2014, 11:31 AM | #6 |
Brigadier General
819
Rep 3,341
Posts
Drives: 2022 M3, 2022 X5 40i;
Join Date: May 2007
Location: Northeast
|
Mine did this after going to a high pressure spray car wash. Transient issue that went away within minutes
|
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
beeping, pdc, sensor |
|
|