|
|
|
09-11-2016, 04:14 PM | #1 |
Private First Class
76
Rep 177
Posts |
29D0 misfiring cylinder 4 after MHD stage 1
Hi all, just flashed to MHD stage 1 91 octane map. Starts up just fine driving a low speeds and RPM is fine as well. Once I go WOT, SES comes on, the car loses a ton of power obviously, and starts shaking really badly.
MHD tool says: -DME active codes- 29D0 Misfirings, cylinder 4 Going to flash back to the stock map for now, is changing spark plugs the only solution? Is there anything else that I need to change/look out for? Thanks guys |
09-11-2016, 06:18 PM | #2 |
First Lieutenant
118
Rep 376
Posts |
How many miles on your car?
Spark plugs should be changed prior to tuning. It will more than likely be a coil pack though. Swap the coil pack on cylinder 4 to another cylinder and see if the misfire follows it. If it does, then change the coil (ideally, change all 6. They're cheap). If the misfire stays on cylinder 4 even after swapping the coil, then it is possible that it is caused by the spark plugs. As I said, you really should have changed them prior to flashing the car. If it's not the spark plug or coil, it's probably the injector. |
Appreciate
0
|
09-11-2016, 07:01 PM | #4 | |
Private First Class
76
Rep 177
Posts |
Quote:
Thanks for the advice. I think I may just end up changing all the coil packs and plugs while I am at it. |
|
Appreciate
0
|
09-11-2016, 07:03 PM | #5 |
Private First Class
76
Rep 177
Posts |
|
Appreciate
0
|
09-11-2016, 08:15 PM | #7 |
Private First Class
76
Rep 177
Posts |
|
Appreciate
0
|
03-25-2018, 03:53 AM | #9 |
Registered
0
Rep 1
Posts |
Help!
Hello all.
I have a 320i 2006 e90. the error codes are 29D0 & 29CC. should i change the catalytic converter or just the sensors? thank you. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|