01-07-2019, 12:15 AM | #1 |
Major
1047
Rep 1,169
Posts |
Rattle after Active Autowerke Midpipe Installed?
After I installed my AA midpipe, there is a rattle at about low RPM and during startup.
Anyone know if this is normal? It is super annoying.
__________________
2018 BMW F80 ///M3
570WHP/578TQ |
01-07-2019, 12:18 AM | #2 |
Major General
3274
Rep 6,723
Posts |
From other posts, you’ll need to possibly add washers under the support brace to give additional clearance
|
Appreciate
1
MisterF80M31047.00 |
01-07-2019, 12:19 AM | #3 |
Colonel
1973
Rep 2,711
Posts |
|
Appreciate
1
MisterF80M31047.00 |
01-07-2019, 12:21 AM | #4 | ||
Major
1047
Rep 1,169
Posts |
Quote:
Quote:
Where can I buy the washer if it is missing?
__________________
2018 BMW F80 ///M3
570WHP/578TQ |
||
Appreciate
0
|
01-07-2019, 12:33 AM | #5 | |
Colonel
1973
Rep 2,711
Posts |
Quote:
Ace, Home Depot, Lowes, or any local hardware shop will have them. Just good old flat washers will do; 2-3 washers per bolt, so roughly 12 total. |
|
Appreciate
1
MisterF80M31047.00 |
01-07-2019, 01:24 AM | #8 |
Major General
3274
Rep 6,723
Posts |
Spacers go on chassis side to give more clearance for the brace. NOT under the bolt head (just in case you weren’t aware)
|
Appreciate
1
MisterF80M31047.00 |
01-07-2019, 09:12 AM | #9 |
First Lieutenant
227
Rep 369
Posts |
If you don’t know where to buy washers, you might want to reconsider modifying your car.
__________________
///M3
|
Appreciate
0
|
01-07-2019, 01:24 PM | #11 |
BimmerPost Supporting Vendor
813
Rep 526
Posts |
The mid pipe can be installed without having to space the brace (although that is a common solution as well). During install, before tightening the ball clamps, we recommend using a small piece of wood or cardboard to space the midpipe between the brace. You can then tighten the ball clamps and remove the spacer. This will allow adequate space between the mid pipe and the brace when everything has been tightened down.
|
Appreciate
1
papasmurf_m3454.50 |
01-07-2019, 02:01 PM | #12 |
Second Lieutenant
46
Rep 211
Posts |
|
Appreciate
0
|
01-08-2019, 07:46 PM | #14 |
Second Lieutenant
66
Rep 200
Posts |
I had this same issue. Add some washers to add clearance to the cross section. Fixed the issue.
__________________
Individual Fire Orange, KW Clubsport 3-way, BMS intake, VRSF chargepipes, Zima V2 DPs, AA midpipe, Hex stage 2, SOLD Alpine White M4- DD |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|