|
|
|
|
|
| 10-14-2013, 12:39 PM | #1 |
|
Enlisted Member
 
9
Rep 37
Posts |
N55 running USB cable from ecu to glove box?
I have looked and looked but I have yet to find a DIY for running a USB cable from the Ecu to the glove box for an N55 setup. I have found DIY's for the N54 but no N55.
I'm sure it's not too hard but having a visual walkthrough would boost my confidence to be able to do this without breaking anything. Please help  |
| 10-14-2013, 03:34 PM | #2 |
|
The Crowing
111
Rep 2,005
Posts |
Pm Loesch. He has his run into the glove box. I'm not sure if he has pics.
__________________
 2009 135i : BMS JB4 G5 ISO,CXRacing FMIC Kit,Injen Cold Air Intake,Evolution Raceworks Charge Pipe,Walboro Inline Fuel Pump, E85 BMS Backend Flash w/ 60% E85,BMS Meth injection (trunkmount),BMS dual meth nozzles,Spec stage 2+ clutch w/ steel SWFW,BMS Catless Downpipes,Berk Tech Race Axleback |
|
Appreciate
0
|
| 10-14-2013, 03:46 PM | #3 |
|
Major
 
652
Rep 1,406
Posts
Drives: 2020 SO - M2C
Join Date: Dec 2010
Location: KOP, PA
|
feed the USB end in the tub in the pic.. it feeds right under the glove box.. just reach up and u can pull it the rest of the way!
 |
|
Appreciate
0
|
| 10-14-2013, 04:02 PM | #4 |
|
The Crowing
111
Rep 2,005
Posts |
If you stare at it for a couple of mins you can see what clips hold it in and just slide out most of plastic walls in there and see the hole in the bottom.
__________________
2009 135i : BMS JB4 G5 ISO,CXRacing FMIC Kit,Injen Cold Air Intake,Evolution Raceworks Charge Pipe,Walboro Inline Fuel Pump, E85 BMS Backend Flash w/ 60% E85,BMS Meth injection (trunkmount),BMS dual meth nozzles,Spec stage 2+ clutch w/ steel SWFW,BMS Catless Downpipes,Berk Tech Race Axleback |
|
Appreciate
0
|
| 10-14-2013, 04:38 PM | #5 | |
|
Enlisted Member
9
Rep 37
Posts |
Quote:
Thanks guys Very helpful as usual  |
|
|
Appreciate
0
|
| 10-14-2013, 04:45 PM | #6 |
|
Enlisted Member
9
Rep 37
Posts |
Also I did a dry run for jb4 install the other night and it looks like either the previous owner or dealer never put everything back together properly
 Last edited by NJ1; 10-14-2013 at 05:03 PM.. |
|
Appreciate
0
|
| 11-15-2013, 11:21 PM | #7 |
|
Lieutenant
 22
Rep 406
Posts |
currently stuck on this install. im running it through the tub but i cant grab it through the glove from the fuse. ive tried to flash a light but the light isnt going through either. any help is greatly appreciated.
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
